Sbc-comm AMD SBC-770 User Manual download pdf (Page 53)

42 SBC-770 User Manual

DiskOnChip (DOC) 2000 Installation

When the DOC is installed correctly, a DOC will work like an HDD

or an FDD. To install the DOC on the mainboard, follow the

instructions below:

1. Plug the DOC into the socket. Make sure pin 1 of the DOC is

aligned with pin 1 of the socket.

2. Push the DOC into the socket until it is firmly seated in the

socket.

Caution: the DOC may be permanently damage if it is installed

incorrectly.

3. Set the jumper for the memory address of the DOC.

Note:

The memory shadow function sometimes will create conflicts with

the memory window. You should disable the memory shadow from

the BIOS SETUP if the DOC cannot be accessed.

Configure DOC as a boot device

To configure a DOC as a boot drive, you should copy the operating

system files onto the DOC. The following procedure is an example

of the initialization process.

1. Install a DOC into your system.

2. Insert a bootable floppy disk in drive A: and boot the system.

3. At the DOS prompt, type SYS C: to transfer the DOS system

files to the DOC (assuming the DiskOnChip is installed as drive

C:). Reboot the system.

4. Go to the BIOS Setup Utility by hitting the <DEL> key. Set the

type of Primary Master or C: Drive as Not Installed.

5. Remove the floppy disk from the drive A: and leave the BIOS

Setup Utility. The system should boot from the DOC.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 110 111

No comments

Sbc-comm AMD SBC-770 User Manual Page 53